Using The Menu Screen - Panasonic NV-DS27 Operating Instructions Manual

CAMERA
VCR
CARD
P.B
MODE
FOCUS
2, 3,
4, 5
MENU
1
FOCUS
1, 2
MENU
PICTURE
No.25 IMGA0012.JPG

Using the Menu Screen

To facilitate the selection of a desired function or setup, this Movie Camera
displays various function setups on Menus.
1
Press the [MENU] Button.
≥The Menu corresponding to the Mode selected using by the [MODE]
1
Button is displayed.
2
Turn the [PUSH] Dial to select a desired Sub-Menu.
≥Turn the [PUSH] Dial to display the highlightened item.
3
Press the [PUSH] Dial to display the selected Sub-Menu.
4
Turn the [PUSH] Dial to select the item to be set.
5
Press the [PUSH] Dial to set the selected item to a desired
mode.
≥With each pressing of the [PUSH] Dial, the cursor [ 1] moves to the
next mode. Menu items that cannot be used in combination with the
selected item are displayed in dark blue.
≥While a Menu is displayed, you cannot record or play back. Menus can be
displayed during playback but not during recording. The above operations
can be done using the [MENU] Button, [SET] Button and [ITEM] Button on
the Remote Controller. (l 8)
To Exit the Menu Screen
Press the [MENU] Button again.
About the Menu Mode Setting
The setting selected on the Menu will be retained even when the Movie
Camera is turned off. However, if the Battery or AC Adaptor is disconnected
before turning off the Movie Camera, the selected setup may not be retained.
(But, the setups of [EFFECT2] (l 25) are not retained.)
≥Menu operation flow is shown in this text by >>.
ª Image Selection (NV-DS37/DS38 only)
A Menu Selection Operation may be necessary during Menu Operations. In
this case, carry out the following procedure.
1 1 1 1
Turn the [PUSH] Dial and select a picture.
≥The selected picture is marked by a frame
2 2 2 2
Press the [PUSH] Dial to confirm the selection of the picture.
≥After the above Picture Selectioin Procedure, carry out the various Menu
Operations. (The above procedure will not be repeated in the following
instructions.)
2
.
13