Table 1-2 Default Settings - Keithley 6514 Instruction Manual

Remote operation
Saving and restoring user setups — The *SAV and *RCL commands are used to save and
recall user setups. These commands are documented in Section 14.
Restoring factory or GPIB default setups — The SYSTem:PRESet command returns
Model 6514 to the factory defaults and the *RST command returns it to the GPIB defaults. The
*RST command is documented in Section 14 and SYSTem:PRESet is covered in Section 16
(SYSTem Subsystem).
Selecting power-on setup — The SYSTem:POSetup command is used to select which setup
to return to on power-up. The SYSTem:POSetup command is documented in Section 16
(SYSTem Subsystem).
Table 1-2
Default settings
Setting
Arm Layer (CONF-ARM):
Arm-In Source Event
Arm Count
Input Trigger Link Line
Source Bypass
Output Trigger Link Line
Output Trigger
Auto Discharge
Level
Buffer (STORE):
Count
Digital Filter (AVG):
Count
Type
Display Resolution (DIGIT)
Function
Guard
GPIB:
Address
Language
Factory
IMM
INF
1
NEVER
2
Off
Off
2e-6
Disabled
No effect
Off
10
Moving
5 -digits
Volts
Off
No effect (On at factory)
No effect (14 at factory)
No effect (SCPI at factory) No effect (SCPI at factory)
Getting Started
GPIB
IMM
1
1
NEVER
2
Off
Off
2e-6
Disabled
No effect
Off
10
Moving
5 -digits
Volts
Off
No effect (On at factory)
No effect (14 at factory)
1-13