Table G-1 Ieee-488 Documentation Requirements; Introduction - Keithley 6514 Instruction Manual

G-2 IEEE-488 and SCPI Conformance Information

Introduction

The IEEE-488.2 standard requires specific information about how the Model 6514 imple-
ments the standard. Paragraph 4.9 of the IEEE-488.2 standard (Std 488.2-1987) lists the docu-
mentation requirements. Table G-1 provides a summary of the requirements and provides the
information or references the manual for that information. Table G-2 lists the coupled com-
mands used by the Model 6514.
The Model 6514 complies with SCPI version 1991.0. Tables 17-1 through 17-9 list the SCPI
confirmed commands and the non-SCPI commands implemented by the Model 6514.
Table G-1
IEEE-488 documentation requirements
(1)
(2)
(3)
(4)
(5)
(a)
(b)
(c)
(d)
(e)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
Requirements
IEEE-488 Interface Function Codes.
Behavior of 6514 when the address is set outside
the range 0-30.
Behavior of 6514 when valid address is entered.
Power-On Setup Conditions.
Message Exchange Options:
Input buffer size.
Queries that return more than one response
message unit.
Queries that generate a response when parsed.
Queries that generate a response when read.
Coupled commands.
Functional elements required for SCPI commands.
Buffer size limitations for block data.
Syntax restrictions.
Response syntax for every query command.
Device-to-device message transfer that does not
follow rules of the standard.
Block data response size.
Common Commands implemented by 6514.
Calibration query information.
Trigger macro for *DDT.
Description or reference
See Appendix F.
Cannot enter an invalid address.
Address changes and bus resets.
Determine by :SYSTem:POSetup
(Section 16).
2048 bytes.
None.
All queries (Common Commands
and SCPI).
None.
See Table G-2.
Contained in SCPI command sub-
systems tables (see Tables 17-1
through 17-9).
Block display messages: 12 char-
acters max,
See Programming Syntax in
Section 12.
See Programming Syntax in
Section 12.
None.
See Display Subsystem in Section
16.
See Common Commands in
Section 14.
Section 19
Not applicable.