Rear Panel; 4-Channel - Lorex LHD100 SERIES Instruction Manual

Rear Panel

4-Channel

1
1 CAMERA INPUTS: Connect up to 4 HD-SDI cameras.
2 AUDIO INPUTS: RCA audio inputs for up to 4 channels.
3 AUDIO OUTPUT: RCA audio output for 1 output channel (e.g. speakers).
4 VGA: Connect a VGA monitor to view the system interface. Note that the DVR cannot use a
VGA and HDMI monitor at the same time.
5 HDMI: Connect an HDMI TV/monitor (recommended) to view the system interface. Note that
the DVR cannot use a VGA and HDMI monitor at the same time.
6 eSATA: Connect an external hard drive (not included) using an eSATA cable.
7 ETHERNET: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
8 RS485/ALARM: Connect compatible PTZ cameras (not included) or alarm sensor devices (not
included).
9 INPUT/OUTPUT Switches: U for up position; D for down position. You must shut down the
DVR to make changes using the INPUT/OUTPUT switches.
NOTE: It is recommended to set all INPUT/OUTPUT switches to the up (U) position for full HD
(1080P) input and output.
• 1 (NTSC/PAL): Select U for NTSC (for North America, recommended) or D for PAL (for Europe).
• 2 (Video Input): Select U for 1080p camera input or D for 720p camera input. You cannot mix
1080p and 720p cameras.
• 3 & 4 (Video Output): Select the correct video output resolution for your monitor using the
table below.
3 4
U U
U D
D U
D D
10 DC12V: Connect the included AC power adapter.
4
2 3
Full HD (1920x1080) - recommended for 1080p HDTVs/HDMI monitors
HD (1280x720) - recommended for 720p HDTVs/HDMI monitors
WSXGA+ (1680x1050)
SXGA (1280x1024) - recommended for VGA monitors
6
4 5
7
Output Resolution
8 9 10