Table of Contents
Advertisement
5
Carefully slide the hard drive panel straight back until it is clear of the SATA connector(s) and
lift it out of the DVR.
6
Turn the hard drive panel over and remove the 4 screws connecting the hard drive to the hard
drive panel. Remove the hard drive from the hard drive panel.
Short side
(install away from
SATA connectors)
Long side
(install facing SATA
connectors)
7
Turn the hard drive panel back over and place it back inside the DVR with the long side (see
above) facing the DVR SATA connectors. Replace the 4 hard drive panel screws.
NOTE: If there is a hard drive still installed, make sure to align the hard drive SATA and power
connectors with the DVR SATA connector and slide the hard drive onto the DVR SATA
connector.
8
Replace the top panel of the DVR by lowering it over the DVR and sliding forward. Make sure
to align the lip on the top panel so it slides under the front panel of the DVR.
SATA connector
Appendix D: Hard Drive Installation
Top lip
(slide under front panel)
Hard drive screws
141
Advertisement
Table of Contents
