Table of Contents
Advertisement
5
Under User Name, enter your DDNS User Name that was emailed to you after DDNS
registration. Click Save & Exit to confirm.
6
Under User Password, enter your DDNS Device password that was emailed to you after
DDNS registration. Click Save & Exit to confirm.
Click Save. Click Exit to return to Live Viewing.
Changing the Web and Client Ports
The DVR's default Client port is 3000. The default Web port is 80. You must forward both
the Client and Web port to access your DVR remotely over the Internet.
To change the Web and Client ports:
1
From Live Viewing mode, right-click to enter the Main Menu. Click Setup then Network.
2
Select the Port tab.
3
Click Client Port and Web Server Port, enter the port number, and click Save & Exit to
confirm.
NOTE: You may only select port 80 or ports greater than 2000.
4
Click Save to save your changes. Click Exit to return to Live Viewing mode.
Enabling Auto Port Forwarding
Auto Port Forwarding allows the DVR to open the required port on your router. Note that
this may not work with your router. If the Auto Port Forwarding feature does not work on
your router, use the Auto Port Forwarding Wizard, located on the software CD, or manually
forward the required ports on your router to your DVR's IP address.
To enable Auto Port Forwarding:
1
From Live Viewing mode, right-click to open the Main Menu. Click Setup then Network.
Configure Client and
Web port
Setup
51
Advertisement
Table of Contents
