• Camera ID: Enter the camera ID.
• Baud Rate: Select the camera Baud Rate.
• Duration: Select the amount of time the camera will remain on presets during Tours before
switching to the next preset.
3
Under Tour Setup, select the order of presets that will be used for Tour 1 and Tour 2.
4
Click Save to save changes.
Time Tab
Configure NTP, Daylight Savings Time (DST), and Auto Reboot settings for the DVR.
To configure NTP:
1
Check Time Server Setup to enable NTP.
Check Time Server
Setup to enable NTP
2
Under Server Type, select NTP (default).
3
Click Save.
To configure Daylight Saving Time settings:
1
Configure the following:
• Time Zone: Select your time zone.
• Daylight Saving Time: Select On to enable or Off to disable.
• Start Time: Select the starting time for Daylight Savings Time.
• End Time: Select the ending time for Daylight Savings Time.
2
Click Save to save your changes.
To configure Auto Reboot settings:
1
Under Auto Reboot, select On to enable or Off to disable.
2
If you select On, select the time you would like the Auto Reboot to occur under Time (Hour)
and the day you would like the Auto Reboot to occur under Repeat.
Remote Viewing Using Internet Explorer
105