Locating Jumpers, Switch, And Connector; Resetting Jumpers And Switch; Figure 3.3 Locating Jumpers, Switch, And Connector - Xantrex XKW 8-350 Operating Manual

Locating
Switch SW1 and jumpers JMP1 and JMP2 are located on the main printed circuit
Jumpers, board (A2) inside the power supply.
provides a procedure for removing the power supply cover and changing jumper and
Switch, and
switch settings. The J3 connector is located on the unit's rear panel.
Connector
Connections" on page 53
connector.

Figure 3.3 Locating Jumpers, Switch, and Connector

Resetting Most applications will use the default factory settings of the internal jumpers, JMP1
and JMP2, or of the internal 8-position DIP switch, SW1. If the jumpers and switch
Jumpers and
should require resetting, follow the procedures in this section.
Switch
The steps to follow are:
•
•
•
•
•
•
•
Revision A
Dissipating stored energy
Removing the cover
Removing the option board (when required)
Resetting JMP1, JMP2 and SW1
Replacing the option board
Replacing the cover
Powering up
Configuring for Remote Programming, Sensing, and Monitoring
"Resetting Jumpers and Switch" on page 51
provides a procedure for changing connections to the J3
FRONT PANEL
A2 PCB
J3 CONNECTOR
PROGRAM, SENSE AND
MONITOR CONNECTOR
REAR PANEL
Operation
"Making J3
1
2
3
4
5
6
7
8
CLOSED
(ON)
51