Rear Panel J1 Connector - Xantrex XPR 10-600 Operating Manual

About The XPR Power Supply
Rear Panel Connectors and Switch
Rear Panel J1 The J1 Programming and Monitoring connector is a 15-terminal wire clamp
connector located on the power supply's rear panel. See
Connector
provides access to the following functions:
•
•
•
•
Figure 1.5 Programming and Monitoring J1 Connector
See
references, and corresponding functions.
22
Remote programming of output voltage AND/OR current limit
Remote monitoring of calibrated readback signals for output voltage and output
current
Remote control of the shutdown function using TTL-compatible signals
(Interlock module)
15 V user supply to allow for contract closure control of the remote on/off line,
current limited
1 Output Voltage Programming Input
2 Output Current Limit Programming Input
3 Program Return
4 Output Voltage Monitor
5 Output Current Monitor
6 Monitor Return
7 N/C
8 Ground Return
9 + 15 V User Signal
10 N/C
11 Interlock Return (–)
12 Interlock Signal (+)
13 N/C
14 Shutdown Return (–)
15 Shutdown (+)
Table 1.2, on page 23 for the list of the J1 connector terminal numbers, their
Operating Manual for XPR Series Power Supply
Figure 1.5. The J1 connector