Programming Output Current Limit; Figure 3.8 Programming Output Voltage With A 5K Ohm Resistance; Figure 3.9 Programming Output Current Limit With A 0-5Vdc Source - Xantrex XKW 8-350 Operating Manual

Programming Output Voltage with a 0-5k Resistance
1. Remove the jumpers connecting pins 8 to 9 and pins 20 to 21 on connector J3.
2. Connect pins 9 (voltage programming input/positive) and 21 (1 mA current
Adjusting the resistance from 0 to 5k will vary the output voltage from 0 to 100% of
the model rating. The output current limit is set locally by adjusting the front panel
current limit control.

Figure 3.8 Programming Output Voltage with a 5k ohm Resistance

Programming
Programming Output Current Limit with a 0-5Vdc Source
Output
1. Remove the jumpers connecting pins 10 to 11 and 22 to 23 on connector J3.
Current Limit
2. Connect the external programming source between pins 10 (current limit
Varying the programming voltage from 0 to 5Vdc will cause the current limit to vary
from 0 to 100% of the model rating. The output voltage is set locally by adjusting the
front panel voltage control.

Figure 3.9 Programming Output Current Limit with a 0-5Vdc Source

Revision A
source for voltage control) to the counter-clockwise end of the 5 k potentiometer
and connect the tap and clockwise end of the potentiometer to pin 12 (return).
programming input/positive) and 12 (return).
Remote Programming of Output Voltage and Current Limit
J3
0 - 5 kΩ
J3
+
0 - 5 V
Operation
59