Controls, Connectors, And Indicators; Load Connection - Xantrex XKW 8-350 Operating Manual

Controls, Connectors, and Indicators

Please refer to
controls and indicators,
panel connectors and switch details, and to
Monitor Connector Description" on page 49
Sense, and Monitor Connector.
Note: J3 pins 1, 2, and 14 form an isolated control function and may be biased
relative to the supply output

Load Connection

Reliable performance of the power supply can be obtained if certain basic
precautions are taken when connecting it for use on the lab bench or installing it in
a system.
To obtain a stable, low noise output, careful attention should be paid to factors such
as conductor ratings, system grounding techniques and the way in which the load and
remote sensing connections are made.
Revision A
CAUTION
!
All remote programming input and monitoring lines are internally referenced to the
supply's negative output. Do not reference remote programming or monitor lines to
the supply's positive output. J3 pin 6 (ground) is directly connected to the supply's
negative output. Do not connect this pin to the positive output or to the chassis.
Figure 1.1, "Power Supply Front Panel" on page 19
Figure 1.2, "Power Supply Rear Panel" on page 20
Figure 3.1, "J3 Program, Sense, and
Controls, Connectors, and Indicators
for a description of the J3 Program,
Installation
for front panel
for rear
37