Rear Panel Connectors And Switch; Controls, Connectors, And Indicators - Xantrex XKW 8-125 Operating Manual

Features and Specifications

Rear Panel Connectors and Switch

Rear Panel Connectors and Switch
The input AC power, output DC power, as well as the remote program sense and
monitor connector are located on the rear panel. The program and monitor function
selector switch (SW1) is located internally on the main PCB. See
15
connections and settings.

Controls, Connectors, and Indicators

Please refer to
controls and indicators,
panel connectors and switch details, and to
Monitor Connector Description" on page 16
Sense, and Monitor Connector.
Note: J3 pins 1, 2, and 14 form an isolated control function and may be biased
relative to the supply output
14
for locations. Refer to
CAUTION
!
All remote programming input and monitoring lines are internally referenced to the
supply's negative output. Do not reference remote programming or monitor lines to
the supply's positive output. J3 pin 6 (ground) is directly connected to the supply's
negative output. Do not connect this pin to the positive output or to the chassis.
Figure 1.1, "Power Supply Front Panel" on page 13
Section 2, "Installation"
Figure 1.2, "Power Supply Rear Panel" on page 15
Figure 1.3, "J3 Program, Sense, and
Operating Manual for XKW 1kW Series Power Supply
Figure 1.2, on page
for detail on procedures for
for a description of the J3 Program,
for front panel
for rear