Table of Contents
Advertisement
Camp-On (Call Waiting)
To answer Call Waiting
beeps from an Intercom
call:
To answer Call Waiting
tones from an outside call:
Understanding Related Programming
Program 1
Program 18 (I)
Program 2
56
Your hear two beeps and ICM flashes.
At a multibutton phone, press ICM to answer the wait-
1.
ing call.
OR
At an ESL set, press HLD and dial * 2.
-Your first call goes on Hold.
-To alternate between the calls, see Split on page
167.
You hear two beeps and a Line/Loop key flashes.
Press HOLD to hold the call you are on.
1.
At a multibutton phone, press flashing Line/Loop key.
2.
OR
At an ESL set, dial * 2.
-To alternate between the calls, see Split on page
167.
To allow/deny Camp-On to a busy extension or line in a
Class of Service (CAMP ON or DIR ACC/CMP-ON =
Y or N + # (see also Program 18 [I])
To allow/deny Privacy in a Class of Service (PRIVACY =
Y or N + #). Allow Privacy for any extension that should
not receive Call Waiting beeps (see also Program 18 [I]).
To assign a Class of Service from Program 1 (COS + # +
01-27 + #) to an extension
To enable/disable Off-Hook Ringing at an extension
(OHR + # + Y or N + #). If enabled, the system converts
the extension's Call Waiting tones to a ring signal over the
speaker.
To enable/disable Call Waiting beeps system-wide
(CALL WAIT TONE = Y + #)
DIGITAL SYSTEM Administrator's Guide
Advertisement
Table of Contents
