Table of Contents
Advertisement
Program 14: Extension Port Char.
Example
Port 03 is set up as follows: It has extension number 307, an Electronic Single Line
Phone connected to it, and the name MR. SMITH.
Port
0 3
3 0 7 0 0
Entering Data Into Memory
To enter Program 14 data:
242
M R
S M I T H
Enter program mode.
1.
-Press # + dial SP + dial 5312 + press #.
Press key 14 to enter Program 14.
2.
Dial Port No., press #.
3.
To accept the displayed data: Press #.
4.
OR
To change or enter data: Dial data, press #.
-To erase a data entry before you press #: Dial *.
-To enter a circuit type of X: Press DIAL, dial X. To
enter circuit type Z: Press DIAL, dial 0.
To enter a name
-Press the dial pad button for the desired letter or
number. To enter a blank space, Q, or Z, press 0.
-To make a letter appear: Dial the number (1, 2, or
3) that corresponds to the letter's position on the
button (e.g. dial 1 if you want the first letter on the
button).
OR
To make a number appear: Dial 4.
Note: To make a blank space, Q, or Z to appear:
Dial 1, 2, or 3, respectively.
-Repeat a-b for all characters (to erase the previous
character, press LAST).
Repeat step 4 for all data.
5.
-If you finish and do not see, "STN PORT NO.":
Press SAVE before step 6.
Select an option:
6.
To enter data for another port: Go to step 3.
OR
To exit Program 14: Press SAVE.
OR
To exit the program mode: Press SAVE twice.
DIGITAL SYSTEM Administrator's Guide
Extension Options
0 1 8 5 3 I 5 ( D )
Advertisement
Table of Contents
