Nitsuko Digital System DS Administrator's Manual page 256

Program 14: Extension Port Char.
Device
XAUX Module
Data Module
(see text below)
You can also install a Data Module (P/N 88400). Before you install the Data
Module, you should do the required programming (see below). If you install the
Data Module (with or without an extension) before you do the programming, you
must unplug the Data Module and extension (if any), then plug them back in.
To program a stand-alone Data Module:
Use Program 14 to assign circuit type Z to the Data Module's port (you must actually
enter ZY on the Program Record Form).
To program a Data Module (installed in an odd port) with a Multibutton Phone
(installed in the consecutive even port):
1. Use Program 14 to assign circuit type 01 to the odd port.
2. Use Program 14 to assign the correct Multibutton circuit type to the even port (01
for a Standard Multibutton or 02 for a Display Multibutton).
3. Use Program 18 (I) to enable the Dataset (DS) option for the even port.
The initial configuration of a Data Module is as follows:
Baud Mode: Slave
Parity: None, 8 bits
Interactive Mode: Yes
Interactive Echo: Yes
RS-232 Controls Active: Yes
To change these settings and for installation instructions, see the Data Products
Manual (N1850DMG01).
Notes:
•
Attendant 01 should be extension 300 and have a Display Phone.
•
The DSS Console is a dual port device, using adjacent even and odd numbered
ports. You must install the DSS Console in the lower (even-number) port of a
port pair. For example, you must plug the console into port 02 (extension 302)
when using the 02/03 port pair.
•
You cannot change the circuit type of a system programming extension while us-
ing it to program; you must use another extension with access level 04 (see Pro-
gram 15).
•
When you install a Multibutton telephone, the system assigns the correct circuit
type. This does not happen for a Data Module, the Multibutton paired with a
Data Module, or an ASI or a Dual OPX/ASI Module.
240
Circuit Type Load Factor
-
Z/01
(no auto-ID)
Allow DTR Disconnect: Yes
Allow Break Disconnect: Yes
Auto Baud: Yes
Busy on DTR Low: No
DIGITAL SYSTEM Administrator's Guide
Extension Options
No. of Ports
0 Exp CEU #1
(w/3 CEUs)
1 1