Table of Contents
Advertisement
For Prime Line:
Program 17
Program 18 (II)
Program 15
For Line Dial-Up:
Program 18 (I)
For Direct Line Access:
Program 1
Program 18 (I)
For Direct Line Group Access (when DIGITAL SYSTEM has AUX
Module):
If you program line groups, the FCC classifies the DIGITAL SYSTEM as a hybrid.
Use the FCC registration number on your CEU that has "MF-E" on the end. If you
do not program line groups, the FCC classifies the DIGITAL SYSTEM as a key
system. Use the FCC registration number on your CEU that has "KF-E" on the end.
Program 11
Program 16
Program 17
For PBX Lines:
Program 5
Program 4
Part I: DIGITAL SYSTEM Features
To assign a line to a key to an extension (LK + Line
number 01-16 + #)
To enable/disable a Prime Line key for an extension (PLA
+ # + Press key + Y or N + #)
To assign program access level 2-5 to extensions so they
can program their own Prime Line key (PGM ACC
LEVEL = 02-05 + #)
To allow/deny Line Dial-Up for an extension (LDU + # +
Y or N + #)
To allow/deny Direct Line (Trunk) Access in a Class of
Service (DIR ACC/CMP-ON = Y or N + #). See also
Program 18 (I).
To assign an extension a Class of Service from Program 1
(COS + # + 01=27 + #)
To place lines into groups (TRK GRP NO. = 90-98 + # +
Line 0-16 + # [repeat last two steps to add additional
lines])
To allow/deny an extension access line groups (G +
Group number 90-98 + # + Y or N + #). With a terminal,
you can program one-digit access to line group 90 using
the QY command
To assign a line group to a key at an extension (LG +
Loop group 00-08 for line groups 90-98 + #)
To store PBX Access Codes (PBX ACC nn = Enter code
+ #)
To set the Flash timer (Timer 08 + # + Duration + #)
Outside Calls, Placing
137
Advertisement
Table of Contents
