Table of Contents
Advertisement
Program 16: Line & Group Access
Entering Data Into Memory
To enter Program 16 data:
Understanding Related Programming
For line access:
Program 10
Program 17
Program 18 (II)
Program 1
Program 18 (I)
Program 12
248
Enter program mode.
1.
-Press # + dial SP + dial 5312 + press #.
Press key 16 to enter Program 16.
2.
Dial extension number, press #.
3.
-To erase a data entry before you press #: Dial *.
Dial L to enter line access data.
4.
OR
Dial G to enter group data.
Dial Line No., press #.
5.
OR
Dial Group No., press #.
To accept the displayed data: Press #.
6.
OR
To change or enter data: Dial data, press #.
Repeat steps 5-6 for remaining lines or groups.
7.
Press SAVE.
8.
Select an option:
9.
To enter line or group data for same extension: Go to
step 4.
OR
To exit Program 16: Press SAVE twice.
OR
To exit the program mode: Press SAVE three times.
-To enter another program after exiting: Press its
key.
To identify line characteristics (type, gain, name)
To assign a line to a key at an extension
To assign a Loop key to an extension. The Loop key
flashes for incoming calls on lines without Line keys.
To assign ringing to lines at an extension
To enable/disable Direct Line (Trunk) Access in a Class
of Service (see also Program 18 [I]). Direct Line Access
lets a user access lines 01-16 by dialing 348-363.
To assign a Class of Service (from Program 1) to an
extension
To allow Line Dial-Up for an extension. This lets a user
access lines 01-16 by dialing 801-816.
To directly terminate a line to an extension so it rings only
that extension. A directly terminated line is both
incoming and outgoing without making it so in Program
16. For more information, see Direct Inward Line on page
64.
DIGITAL SYSTEM Administrator's Guide
Extension Options
Advertisement
Table of Contents
