Printronix PrintNet P8000 Line User Manual page 200

Chapter 12
Complete Command List
load [default]
Load the settings stored in flash memory and use them as the
current or working settings. If default is specified as well,
factory settings will be loaded.
lpstat [jobID]
Example: lpstat
Display active and queued jobs and printer status for a given
printer or jobID. Specifying one of these parameters will
shorten the output and focus on the particular I/O port or print
job specified.
cancel jobID
Example: cancel d1prn-10
Remove a job from an I/O port queue. Use lpstat to find a
particular job ID first.
start emi|fox
Example: start fox prn
Begin a test on the PrintNet. The tests available are:
fox
emi
stop
Stop the current test running.
disable destination|ftpc|ftp|telnet
Example: disable
Disable a protocol or disable a destination so jobs cannot
be queued to it. You can also disable ftpc, ftp, or telnet protocol
using the disable command.
200
A continuous stream of text sent to the
attached printer. This is a good test for
troubleshooting hardware as long as the
attached printer supports text output.
This is reserved.