Printronix PrintNet P8000 Line User Manual page 181

store pserver lpd [-]dest1default
Example: store pserver lpd dest1default
If dest1default is disabled and upon verification, the printer
name supplied by the LPR protocol and the destination name
do not match, then an error message is returned and the
service is refused. If dest1default is enabled and upon
verification, the printer name supplied by the LPR protocol and
the destination name do not match, then the job is
automatically routed to the first destination and the service is
accepted.
Default: enabled
store pserver ftp [-]dest
Example: store pserver ftp dest
This command is to set the default directory when ftp is
launched. Example commands as follows:
set dest d1prn name pr1
store pserver ftp dest
save
The first command changes <dest> d1prn to pr1. The second
command tells ftp to start at directory dest. To send the print
job, ftp to the printer and enter 'put printjob pr1'.
store pserver from default
Set all general print server settings back to factory defaults.
store pserver from current
Store all current general print server settings to flash memory
so they are retained after a power cycle. This ensures all
current settings match what is stored in flash memory.
store ptrmgmt pne <PNE PORT NUMBER>
Change the port number to communicate with Printnet
Enterprise.
Default: 9001
Store Commands
181