Printronix PrintNet P8000 Line User Manual page 189

set logpath <LOG_NAME> type [[-]job] [[-]pfault]
Example: set logpath l2 type job user printer
Establish the type of printer and print job logging to be done
within this <logpath>. The option is:
job Job ID, username, etc.
pfault Printer fault
set logpath <LOG_NAME> email <EMAIL>@<IPADDRESS>
Example: set logpath l3 user@printronix.com
Determine where the log information should be sent for a print
job or attached printer. The choice is:
email Particular user's email address. This address
is set using the set sysinfo email
emailname@IPaddress or
emailname@domain.com command.
set logpath from default|stored
Set all logpath settings back to factory defaults or the values
stored in flash memory.
set lpd [-]bytecount
Example: set lpd -bytecount
Set the job control on the file size of a Line Printer Daemon
(LPD). If bytecount is enabled, the printer does not allow the
LPD client to send a job with an unconventional file size.
Usually the unrecognized numeric operand in the LPD Receive
Data File command attributes to this behavior. The print job
stream is canceled and its TCP connection is closed.
Default: Disabled.
set lpd [-]offlinedata
The offlinedata flag helps minimize host disconnects when the
printer goes offline for an extended time. Enable this option if
you experience host disconnects when the printer goes offline.
Set Commands
189