Configuring Psf/400 For Ipds On V3R7 And Above - Printronix PrintNet P8000 Line User Manual

Chapter 8
Configuring on AS/400 as an IPDS Printer
Configuring PSF/400 for IPDS on V3R7 and
Above
To configure IPDS on AS/400 V3R7 and above, use the following
commands:
•
CRTPSFCFG (Optional)
•
CRTDEVPRT
Configuring AFP with CRTPSFCFG on V3R7 or
V4R1 (Optional)
New for V3R7 is the ability to specify three TCP/IP-related
parameters for PSF in a printer device description: RMTLOCNAME,
PORT, and ACTTMR. In V3R2, CRTPSFCFG, which replaced
WRKAFP2, was used to specify these same parameters, along with
other parameters. In V3R7 and higher, these three parameters are
ignored when specified in a PSF configuration object, since they
are specified in a printer device description. However, you may
wish to use a PSF configuration object to specify other parameters,
such as IPDS passthrough and so on.
The PSF configuration object created with this command is used by
PSF/400 when printing IPDS files only if the object is specified with
the USRDFNOBJ parameter in the printer device description.
To configure AS/400 for IPDS printing on V3R7 or V4R1:
1. At the AS/400 command line, enter a command in the form:
CRTPSFCFG
where printer_type (e.g., T5000, P7000) is the model of
your printer.
126
PSFCFG(AFP/printer_typeNETPRT)
IPDSPASTHR(*YES) RLSTMR(*SEC15)
TEXT('printer_type NETWORK PRINTER')