Miscellaneous Commands - Printronix PrintNet P8000 Line User Manual

list user
List the current user definitions (e.g., user names and types).
list var
List all pre-defined variables including any newly created ones.
Any of these defined variables can be referenced in a string by
placing a "$" before the variable name (e.g., set model m1
trailer $FF).
list dhcp
List all DHCP information for the PrintNet provided that DHCP
is enabled.
list lpd
List the Line Printer Daemon (LPD) information, such as
whether the bytecount is enabled or disabled.

Miscellaneous Commands

These commands do not fall under any specific section of the
command shell, but they are used quite frequently.
save [default]
Save the current settings to flash memory so they are available
after power cycles. Sysinfo, destination, model, logpath,
variable, user, and I/O port settings will be saved. If
is specified as well, factory settings will be saved, overwriting
any new settings you have configured.
reboot
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
reset
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
Miscellaneous Commands
default
199