Wiring The Base Plate Terminals; Fuel Burner Hvac - Proliphix Thermostat Installation Manual

Installing and Wiring the Thermostat

Wiring the Base Plate Terminals

Use the instructions in this section to wire the base plate terminals as follows:

Fuel Burner HVAC

Use the instructions in this section and refer to
plate for fuel burner HVAC. Refer to the labels you placed on the wires when you
removed the existing thermostat
Table 1
required to support the single-stage and dual-stage application.
Table 1 Fuel Burner Terminal Conversion Chart
Standard
Terminal
R, RH
RC
C
W, W1
Y, Y1
W2
Y2
G
-
-
a
4
Wire the NT10e/NT20e base plate for fuel burner HVAC
HVAC (page 6).
Wire the NT100e/h, NT120e/h, NT125e/h, and NT150e/h for fuel burner HVAC
(page 4) and heat pump HVAC
lists the standard HVAC terminal label and the corresponding Proliphix label
Proliphix
Terminal
RH
RC
C
W1
Y1
W2
Y2
G
S1+ or
CM
H
For "h" thermostat models only, the 24VAC common must be in the same AC phase as the 24VAC
source (RH or RC). If the thermostat is connected to RH only, or RH and RC then C must be the RH
common. If the thermostat is connected to RC only then C must be the RC common.
Beta Draft Confidential
(page 6).
Table 1
(page 2).
NT10e/NT20e NT100e/h, NT120e/h, NT125e/h,
and NT150e/h
24VAC source 24VAC source
24VAC source 24VAC source
Not used
Not used or 24VAC common
Heat relay Stage 1 heat relay
Cool relay Stage 1 cool relay
Not used Stage 2 heat relay
Not used Stage 2 cool relay
Fan relay Fan relay
Not used Contact closure common (NT150 only)
Not used Contact closure, Active open or Active closed
(NT150 only)
Proliphix Thermostat Installation Guide, Release 1.0
(page 4) and heat pump
and Figure 1 to wire the base
a
Part No. 600-01000-100