Mitel 1000 Owner's Manual page 58

For configuration via the Featurephone interface, see page 161.
Least Cost Routing
You may use this feature to have users' calls routed over specific lines, or over
a specific Network Provider. To set the feature up you associate input codes
with the lines over which calls should be routed and with whatever network
codes are necessary to route the call.
In addition you can choose to route the calls over different lines at various
times of the day for optimum call rates. Once the facility is activated calls are
automatically routed over the selected lines, and the network code is sent to
the line before the telephone number.
To route a call using the Least Cost Routing feature
Select a Line Key, or dial a code for a line (9, 8) and select 'Send digits'.
Dial a valid input code.
When a line is selected, dial the telephone number you wish to reach.
Your call will then be connected with the output code being dialed before the
telephone number.
Any Line Key or line code (9, 8) can be selected above. However, the system
will select the line for the call based on the input code.
To set up codes to allow calls to be routed on specific lines or networks
For configuration via the web interface, see page 112.
For configuration via the Featurephone interface, see page 162.
Least cost Routing activated automatically at set times
For configuration via the web interface, see page 112.
For configuration via the Featurephone interface, see page 162.
Sending a Forward Recall while on call
A Forward Recall signal may be required if you are using certain network
services on standard CO lines, or if your Mitel 1000 is connected to another
telephone system (PABX) via one of the line interfaces.
The Forward Recall feature allows you to send a hold signal forward on the
line to the exchange or PABX. To send a hold signal, you must be on a call or
have dialed at least one digit of the number you are calling.
To send a Forward Recall signal to an exchange or a PABX
From a Featurephone, select 'Forward recall' on the display.
From a standard telephone, the code is Hookflash 722.
58