Mitel 1000 Owner's Manual page 37

Select the required feature to be programmed onto the key. Use the Scroll
Down Key ( ) to scroll down to view the list of available features. For
example, to program the key with a speed dial number, select the 'MF Digits to
line' option.
Press the Speakerphone Key to finish programming.
If you are programming the key to call an external number
remember to precede the number with a
Note
to select an IP Trunk.
To turn on Headset Mode
You turn Headset mode on and off via the PROGRAM Key
From your Featurephone, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'Headset Mode' is displayed.
Select 'Headset mode'.
Select the required option – 'Headset on' or 'Headset off'. Once selected, the
display will show 'Headset On' or 'Headset Off' and then revert to the Idle
Menu.
Press the Speakerphone Key to finish programming. The options to Turn
headset On? And turn Headset Off are shown on the Idle display.
The handset does not operate in Headset Mode.
To set a ringing tone on your Featurephone
You can select one of six ringing tones.
From your Featurephone, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'Ringing Options' is displayed.
Select 'Ringing options'.
Select 'Tone 1', 'Tone 2', 'Tone 3', 'Tone 4', 'Tone 5' or 'Tone 6' which will
cause the selected tone to sound.
Select 'Confirm' to use the chosen tone. On the display 'Ring type set' will
appear and then the display will revert to the Idle Menu.
Press the Speakerphone Key to finish programming.
To set the display contrast on your Featurephone
You may choose from four levels of display contrast.
From your Featurephone, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'Contrast Options' is displayed.
Select 'Contrast options'.
Select 'Level 1', 'Level 2', 'Level 3' or 'Level 4' to set a contrast option. The
prompt 'Contrast set' appears on the display.
Press the Speakerphone Key to finish programming.
To enter system programming
If your extension is the Programming Extension you have access to the system
programming options. If you select this option you will be prompted to enter
the System Programming Password. If this option is selected from any other
extension the display will show 'Programming Refused'. Again, the default
Programming extension is extension 20.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is displayed.
Select 'System programming'.
Enter the System Programming Password to access system programming
(1111 in default).
37
9 to select the CO line or 8