Mitel 1000 Owner's Manual page 160

To set up your system to display caller numbers received on CO
lines (Caller ID service)
If you subscribe to the Caller Number display service from your
Network Provider then you can program the system to display the
callers number.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'PSTN Programming' is
displayed.
Press the Scroll Down Key ( ) until 'Caller ID Detection' is
displayed.
Select 'Caller ID detection'.
Select the lines that have the Caller ID service enabled. The lines
you select will have a ♦ displayed beside them.
Press the Speakerphone Key to finish programming.
To associate a caller number with a name, and route its calls to an
extension
Up to a hundred names, each a maximum of ten characters,
(including spaces), may be associated with caller telephone
numbers. When a number with an associated name is received,
the name rather than the number is displayed.
Furthermore an extension number may also be associated with a
telephone number. In this case an incoming call from that number
will ring at only that extension..
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System Programming' is
displayed.
Select 'System Programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'CID Programming ' is
displayed.
Select 'CID Programming .'.
Select an Index Number (01 - 30).
Enter the caller telephone number.
Press 'Confirm'.
Enter the name to be associated with the number. Refer to page 35
for help on how to enter names.
Select the destination you wish to route calls from that number to.
Caller ID Lists – storing all calls or unanswered calls only
The system Caller ID lists can store either all calls or unanswered
calls only.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System Programming' is
displayed.
Select 'System programming'.
160