Mitel 1000 Owner's Manual page 126

If you want to use WEP 128bit data encryption, click on the 128bit
encryption on the wireless network radio button and then click
Next>. Now follow the instructions in Configuring 64bit or 128bit
encryption on page 126.
If you want to use WPA, click on the Wi-Fi Protected Access (WPA)
on the wireless network radio button and then click Next>. Now
follow the instructions in Configuring WPA security on page 127.
Disabling the Broadcast of the SSID Network Identifier
For additional security you can disable the broadcast of the Network
Identifier, SSID. Unticking the Enable SSID Broadcast button on the
Wireless security page does this. To connect to a network that is not
broadcasting the SSID it is necessary to enter the SSID manually in
the network connection properties in the Control panel of your PC.
Configuring 64bit or 128bit encryption
The example set in this section is for 128bit encryption, however the
outline also applies to 64bit encryption.
1. Once you have selected your WEP encryption method and
then clicked Next>, the following page is displayed:
2. Click in the Key box and type a unique 26-character hex
network key, such as A6F34B2CE5D68BE90A6F34B2CE.
Hexadecimal or 'hex' numbers each have a value of 0 to 9 or A to
F. Each number represents four bits of binary data.
Note
Note that if you selected 64bit, you will need to type a unique 10-
character hex network key.
3. Click Next>.
If you are following the First Time Settings wizard, the next page in
the wizard sequence is displayed, which allows you to Configure
Wireless Address Authentication.
If you have accessed this page from the General Settings section of
the Wireless Network page, click on the Confirm Changes button to
apply changes and return to the Wireless Network page.
126