Mitel 1000 Owner's Manual page 50

Making CO Line Calls
There are two modes of operation available for making CO Line calls. The
normal mode, which is the default, a line access digit is dialed to select a CO
Line. If Automatic Line selection is programmed you do not enter the line
access code.
To make an external call in normal mode
1. Lift the handset, or use a Speakerphone Key, if available on your
telephone.
2. Obtain a free line in one of the following ways:
3. Dial 9, (to select a CO line).
4. Dial 8, (to select an IP Trunk).
5. Dial the number you require.
To make an external call in Automatic Line selection mode
3. Lift the handset, or use a Speakerphone Key, if available on your
telephone.
4. Dial the number.
5. The system automatically selects a free line and the number is dialed.
To make an internal call in normal mode
1. Lift the handset, or use a Speakerphone Key, if available on your
telephone.
2. Dial the desired
To make an Internal call in Automatic Line selection mode
1. Lift the handset, or use a Speakerphone Key, if available on your
telephone.
2. Press hookflash and dial the desired extension number (20-23 or 31-
34)
To answer a call
When the telephone rings, lift the handset, or use a Speakerphone Key if
available on your telephone.
Holding & Transfer Calls
To place a call on hold
1. Press the Recall Key or Hookflash.
If you replace the handset, you can continue to use your telephone. The held
call will call back within ninety seconds provided your telephone is idle. If you
are busy on the telephone after the ninety seconds the call will ring when the
handset is replaced.
To transfer a call
1. Press the Recall Key or Hookflash.
2. Dial the
extension
50
number (20 -23 or 31-34).
extension
number and replace the handset.