B Cordless Phone Detailed Instructions - Mitel 1000 Owner's Manual

Cordless Phone Detailed Instructions
B
WARNING
WARNING
Battery requirements: The handset requires power source of two
rechargeable NiMH batteries, size AAA 1.2V 750mAh (HR10/44).
Safety precautions:
•
Do not allow the handset to come into contact with liquids or
moisture.
•
Do not allow the charging contacts or the battery to come into
contact with conductive materials.
•
There is a slight chance that the telephone could be damaged
by an electrical storm. It is recommended that users unplug the
phone from the mains supply and telephone socket during a
storm.
•
Do not use the handset in an explosive hazard area such as
where there is gas leaking.
•
Because the phone works by sending radio signals between
the base unit and the handset, wearers of hearing aids may
experience interference in the form of a humming noise.
•
We advise that this phone should not be used near intensive
care medical equipment or by persons with pacemakers.
•
Your phone can interfere with electrical equipment such as
answering machines, TV and radio sets, clock radios and
computers if placed too close. It is recommended that you
position the Mitel 1000 at least one meter from such appliance
Use only the mains adapter supplied with this telephone.
Incorrect adapter polarity or voltage can seriously damage the
telephone. Input: 110 VAC 50 Hz Output: 9 VDC 300 mA
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS
REPLACED BY AN INCORRECT TYPE. Never use
nonrechargeable batteries. Use two rechargeable NiMH
batteries, size AAA 1.2V 750mAh (HR10/44) only. NiMH batteries
must be disposed of in accordance with the applicable waste
disposal regulations.
Setting up your phone
1. Connect the output plug of the mains adapter to the socket on
the back of the charger unit and the mains adapter to the wall
mains supply.
2. Place the 2 rechargeable NiMH AAA batteries (included),
observing their polarities, into the battery compartment on the
handset. Slide the battery door firmly into place.
3. Place the handset on the base unit and let the batteries charge
for a full 14 hours before using it for the first time.
184