Mitel 1000 Owner's Manual page 181

Programming Caller ID Detection
On standard CO lines on the Mitel 1000 the 'Caller ID Detection'
option is programmed. The system can then detect when Caller ID
information is being sent from the network and display the number.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'PSTN programming' is
displayed.
Select 'PSTN programming'.
Press the Scroll Down Key ( ) until 'Caller ID Detection' is
displayed.
Select 'Caller ID Detection' The lines with 'Caller ID Detection'
programmed are indicated with a ♦.
Programming Dialtone Detection
This feature is provided as a programmable option under CO
programming and is enabled to prevent the system from dropping
the line when dial tone has not been detected. When enabled dial
tone is not detected and the line is released if no digit is dialed until
the expiration of the "Dialing time-out timer"
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'PSTN programming' is
displayed.
Select 'PSTN programming'.
Press the Scroll Down Key ( ) until ' Dialtone detection' is
displayed.
Select ' Dialtone detect' The lines with ' Dialtone detection' enabled
are indicated with a ♦.
Long CO Line
In some situations if the transmission on the CO Line is poor it may
be necessary to change this setting which changes the impedance
presented to the line.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'PSTN programming' is
displayed.
Select 'PSTN programming'.
Press the Scroll Down Key ( ) until ' Long CO Line' is displayed.
Select ' Long CO Line'. The lines with ' Long CO Line' enabled are
indicated with a ♦.
181