Table of Contents
Advertisement
Digital Projection
E-Vision 8000 series
Operating the Projector
Switching the Projector On
•
Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
•
Wait until the self-test has completed and the Power indicator on the projector control panel shows red. The lamp will be off and the
projector will be in STANDBY mode.
•
Press
on the control panel or
POWER
The Power indicator on the control panel will flash green for a few seconds whilst the lamp comes up to full brightness. When the
projector is ready for use, the Power indicator will show steady green.
Selecting an Input Signal or Test Pattern
Input signal
•
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within a
two or three seconds.
•
If more than one signal is connected, then select the image you want to display:
Press
INPUT
repeatedly on the control panel or remote control to cycle through the inputs.
or use
Input Selection
in the
INPUT menu
Test pattern
If you have an image source connected to the projector, then you can display a test pattern instead:
Press
repeatedly on the remote control to cycle through the test patterns,
TEST PATTERN
or select a
from the
Test Pattern
To return to viewing the image from your image source, scroll through the test pattern list to
Rev A
April 2012
on the remote control.
POWER ON
.
.
INPUT menu
OPERATING THE PROJECTOR
Off
.
Installation and Quick-Start Guide
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
For full details of how to connect an
image source to the projector, see
the Connection Guide.
For full details of how to use the
controls and the menu system, see
the Operating Guide.
If there is no image source
connected to the projector, then
the Test Pattern feature is NOT
available.
Page Inst_8
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the E-Vision 8000 Series and is the answer not in the manual?
Questions and answers