Operating The Projector; Operating The Projector; Switching The Projector On - Digital Projection INSIGHT 4K Laser Series Installation And Quick Start Manual

Digital Projection INSIGHT 4K Laser Series

Operating The Projector

Switching the projector on

1. Make sure the power switch
1
position. Connect the power cable between the mains supply and the
projector, then turn the power switch on.
The SYSTEM status indicator lights a steady amber to show that the
projector is now in STANDBY mode.
2. (optional step) If no button is pressed within 30 seconds of the projector
entering STANDBY mode, the control panel becomes locked.
To unlock the control panel, press and hold the
second or longer.
3. To switch from STANDBY to ON mode, press and hold the
for three seconds or longer.
During the startup process, the SYSTEM
When the projector is fully switched on, the
steady green.
Installation and Quick-Start Guide
above the AC mains inlet is in the OFF
button for one
KEY LOCK
POWER button
status indicator flashes green.
status indicator lights a
SYSTEM

OPERATING THE PROJECTOR

1
Notes
Connecting The Power
See also
Supply earlier in this guide.
Do not turn off the projector from
the power switch or disconnect
the power cord while the
projector is working or cooling
down.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Rev C June 2016
page 16