Switching The Projector On; Switching The Projector Off; Selecting An Input Signal - Digital Projection E-Vision Laser 8500 Series Important Information Manual

Important Information

Switching the projector on

Connect the power cable between the mains supply and the projector. (See Connecting the
1.
power supply above.) Switch on at the switch next to the power connector.
2. The indicator lights red to signal that the projector is in STANDBY mode. Press one of
POWER
the following buttons:
•
On the remote control, the
•
On the projector control panel, the
The fans begin working, then the
stops, the
POWER

Switching the projector off

1. Press on the remote control or
OFF
your choice.
The indicator on the control panel will start flashing amber, the system will go out and the
POWER
cooling fans will run for a short time until the
the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
main menu, press
buttons. Press
Page 14
button
ON
POWER
and indicators both light steady green. The projector is switched on.
LIGHT
POWER
and then select an input signal using the
ENTER/OK
to confirm your choice.
ENTER/OK
Digital Projection E-Vision Laser 7500 & 8500 Series
button.
POWER
indicator begins flashing green. When the flashing
on the control panel, then press again to confirm
indicator goes stready red to indicate that
POWER
. Highlight
MENU Input
and
UP DOWN
Rev D January 2017
from the
arrow