Table of Contents
Advertisement
Digital Projection Ltd. Titan Laser WUXGA
Operating the projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. (See Connecting the power supply above.) Switch the breaker switch next to the
power connector to on.
The POWER indicator turns red to signal that the projector is on and in STANDBY mode.
2. Press one of the following buttons:
On the remote control, the ON button
l
On the projector control panel, the POWER button.
l
The POWER indicator begins flashing green as the projector powers up. When the flashing stops, the POWER indicator lights solid green and the Digital Projection
logo appears on the screen. The projector is switched on and projecting.
Switching the projector off
1. Press OFF on the remote control or POWER on the control panel, then press again to confirm your choice.
The POWER indicator on the control panel will start flashing blue, the projected image will turn off and the cooling fans will run for a short time until the
POWER indicator goes steady red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch the breaker switch next to the power connector to off and then disconnect the power cable from the
projector.
Selecting an input signal
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
Press one of the input buttons on the remote control.
l
Alternatively, open the On-screen display (OSD) by pressing MENU. Highlight Input from the main menu, press ENTER/OK and then select an input
l
signal using the UP and DOWN arrow buttons. Press ENTER/OK to confirm your choice.
Selecting a test pattern
To display a test pattern:
Press TEST on the remote control.
l
Change the test pattern using the LEFT and RIGHT arrow buttons. The following test patterns are available: White, Black, Red, Green, Blue, Checkerboard,
Crosshatch, V Burst, H Burst, Color Bar, Off.
Alternatively, open the OSD by pressing MENU. Highlight Test Patterns from the main menu, then select a test pattern using the LEFT and RIGHT arrow
l
buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you need to press TEST again. If you wish
to exit the test patterns before you reach the final one, press TEST or EXIT at any time.
Rev B September 2019
page 32
Operating the projector
Notes
See Connecting the
power supply on page 13.
The self-test is running
when all the LEDs on the
control panel are lit.
Use only the power cable
provided.
Ensure that the power
outlet includes a ground
connection as this
equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a
damaged power cable.
See Using the menus on
page 44 for full details of
how to use the controls
and the menu system.
Installation & Quick Start Guide
Advertisement
Table of Contents
