Table of Contents
Advertisement
Digital Projection INSIGHT Laser 8K Series
Operating The Projector
Switching the projector on
1.
Connect the power cable between the mains supply and the socket
ON/OFF switch
.
2
2.
Press
ON
on the remote control or the control panel to switch the projector ON.
The run indicator on the control panel will flash blue until the projector has warmed up. The light
source will light and the shutter will open.
The run indicator will show a continuous blue light and the standby indicator will show green when
the projector has warmed up.
Switching the projector off
1.
Press
OFF
twice on the remote control or the keypad.
The run indicator on the control panel will flash blue until the projector has cooled down. The
cooling fans will run for a short time until the projector enters STANDBY mode.
The run indicator will show a continuous blue light and the standby indicator will show green when
the projector has cooled down.
2.
If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.
Selecting an input signal
The last selected input remains active until a new input is selected. To select a new input:
1.
Connect ither a 3G-SDI or 12GSDI image source to the projector. Refer to the "Connection Guide"
2.
Select the appropriate resolution:
1.
Press
to open the On-screen display (OSD).
MENU
2.
Use the
and
arrow buttons to highlight
UP
DOWN
3.
Use the
and
arrow buttons to highlight
UP
DOWN
4.
Use the
and
arrow buttons to highlight a setting. Choose from
UP
DOWN
choice.
Installation and Quick-Start Guide
OPERATING THE PROJECTOR
. Switch on at the
1
from the main menu and press
Input
from the input menu and press
Format
,
,
Auto
8K
4K
.
ENTER/OK
.
ENTER/OK
or
. Press
to confirm your
HD
ENTER/OK
Notes
Connecting The Power
See also
Supply
earlier in this guide.
Do not turn off the projector from
the power switch or disconnect
the power cord while the
projector is working or cooling
down.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
1
2
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Rev A October 2018
page 16
Advertisement
Table of Contents
