Operating The Projector; Switching The Projector On; Switching The Projector Off; Selecting An Input Signal - Digital Projection E-Vision Laser 13000 WU Series Installation & Quick Start Manual

Operating the projector

Switching the projector on

1. Ensure a lens is fitted. Connect the power cable between the mains supply and the projector. (See Connecting the power supply above.) Switch on at the
switch next to the power connector.
2. The POWER indicator lights red to signal that the projector is in STANDBY mode. Press one of the following buttons:
On the remote control, the ON button
l
On the projector control panel, the POWER button.
l
The fans begin working, then the POWER indicator begins flashing green. When the flashing stops, the POWER and LIGHT indicators both light steady green. The
projector is switched on.

Switching the projector off

1. Press OFF on the remote control or POWER on the control panel, then press again to confirm your choice.
The POWER indicator on the control panel will start flashing amber, the system will go out and the cooling fans will run for a short time until the POWER
indicator goes steady red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect the power cable from
the projector.

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
Press one of the input buttons on the remote control.
l
Alternatively, open the On-screen display (OSD) by pressing MENU. Highlight Input from the main menu, press ENTER/OK and then select an input
l
signal using the UP and DOWN arrow buttons. Press ENTER/OK to confirm your choice.

Selecting a test pattern

To display a test pattern:
Press TEST on the remote control.
l
Change the test pattern using the LEFT and RIGHT arrow buttons. The following test patterns are available: White, Black, Red, Green, Blue, Checkerboard,
Crosshatch, V Burst, H Burst, Color Bar, Screen Layout, Off.
Alternatively, open the OSD by pressing MENU. Highlight Test Patterns from the main menu, then select a test pattern using the LEFT and RIGHT arrow
l
buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you need to press TEST again. If you wish
to exit the test patterns before you reach the final one, press TEST or EXIT at any time.
Installation & Quick Start Guide
Operating the projector Digital Projection Ltd. E-Vision Laser 13000 WU Series
Notes
See Connecting the
power supply on page 11.
The self-test is running
when all the LEDs on the
control panel are lit.
Use only the power cable
provided.
Ensure that the power
outlet includes a ground
connection as this
equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a
damaged power cable.
See Using the menus on
page 36 for full details of
how to use the controls
and the menu system.
Rev A June 2019
page 23