Table of Contents
Advertisement
Infrared reception
The projector has infrared sensors at the front and rear.
The angle of acceptance is 40°. Make sure that the remote control is within the angle of
acceptance when trying to control the projector.
Switching the projector on
1. Ensure a lens is fitted. Connect the power cable between the mains supply and the projector.
2. Switch on at the switch next to the power connector.
3. Press one of the following buttons:
On the remote control, the ON button
l
On the projector control panel, the POWER button.
l
The POWER indicator begins flashing green and the fans start working. When the flashing stops and the POWER and LIGHT indicators both light steady green,
the projector is switched on.
Switching the projector off
1. Press OFF on the remote control or POWER on the control panel, then press again to confirm your choice.
The POWER indicator on the control panel will start flashing amber, the system will go out and the cooling fans will run for a short time until the POWER
indicator goes steady red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect the power cable
from the projector.
Interlock reset
In the event of the laser illumination turning off as a result of an Interlock break:
1. Make sure all interlocks are in place. See Interlock Switches on page 15
2. Turn ON the laser illumination as above
Installation & QuickStart Guide
Operating the projector
40˚
40˚
Digital Projection E-Vision Laser 15000 Series
Notes
Rev B April 2021
page 33
Advertisement
Table of Contents
