Digital Projection E-Vision 8000 Series User Manual page 39

Digital Projection
E-Vision 8000 series
continued
PICTURE Menu
Overscan
•
Set this to or as required.
Off On Zoom
VGA Setup sub menu
•
Press ENTER to open the VGA Setup sub menu.
Horizontal Total, Start and Phase, Vertical Start
•
Adjust the sliders for these settings, as required to suit the incoming image.
Auto Sync
•
Press ENTER to force the projector to re-synchronise with the input signal.
Rev A April 2012
A TOUR OF THE MENUS Operating Guide
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Overscan is used to compensate
for noisy or badly defined image
edges, by cropping the image, or
increasing the size of the image to
force the edges off-screen.
Page Op_11