Table of Contents
Advertisement
Digital Projection
E-Vision 8000 series
Switching the Projector Off
•
Press and hold
on the control panel or
POWER
The lamp will go off, and the Power indicator on the control panel will flash amber for a few seconds whilst the lamp cools. The Power
indicator on the control panel will then show red and the projector will be in Standby mode.
•
Switch off at the switch next to the power connector. Disconnect the power cable from the projector.
Rev A
April 2012
OPERATING THE PROJECTOR
on the remote control for 5 seconds.
POWER OFF
Installation and Quick-Start Guide
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Page Inst_10
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the E-Vision 8000 Series and is the answer not in the manual?
Questions and answers