Table of Contents
Advertisement
Digital Projection E-Vision Laser 15000 Series
Basic Operating Instructions
Switching the projector on
1. Ensure a lens is fitted. Connect the power cable between the mains supply and the
projector.
2. Switch on at the switch next to the power connector.
3. Press one of the following buttons:
On the remote control, the ON button
l
On the projector control panel, the POWER button.
l
The POWER indicator begins flashing green and the fans start working. When the flashing
stops and the POWER and LIGHT indicators both light steady green, the projector is switched
on.
Switching the projector off
1. Press OFF on the remote control or POWER on the control panel, then press again to
confirm your choice.
The POWER indicator on the control panel will start flashing amber, the system will go
out and the cooling fans will run for a short time until the POWER indicator goes steady
red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch
next to the power connector and then disconnect the power cable from the projector.
Interlock reset
In the event of the laser illumination turning off as a result of an Interlock break:
1. Make sure all interlocks are in place. See Interlock Switches on page 17
2. Turn ON the laser illumination as above
Selecting an input signal
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
Press one of the input buttons on the remote control.
l
Alternatively, open the On-screen display (OSD) by pressing MENU. Highlight
l
Input from the main menu, press ENTER/OK and then select an input signal
using the UP and DOWN arrow buttons. Press ENTER/OK to confirm your
choice.
Rev B April 2021
page 30
Basic Operating Instructions
Important Information
Advertisement
Table of Contents
