Hardware Installation And Startup; Installation Overview - Sun Microsystems sun fire V20Z Installation Manual

Hide thumbs Also See for sun fire V20Z:

Table of Contents

C H A P T E R

Hardware Installation and Startup

Before performing any procedures, become familiar with the physical orientation

and features of your Sun Fire

Refer to the Sun Fire V20z Server User Guide for detailed information about the

server.

After unpacking your server, perform the following tasks, which are described in the

documentation as indicated:

1. Add any PCI expansion cards or hardware options that you want to install. Refer

to the Sun Fire V20z Server User Guide or the documentation shipped with the

hardware option for instructions on removing the system cover and installing the

option.

2. If desired, install the server in a rack using orderable slide-rails. See "Installing

the Server Into a Rack" on page 2.

3. Connect all cables and power cords. Refer to "Cabling" on page 5 of this guide.

4. Connect your peripherals. Refer to

the server's back panel connector ports.

5. Power on and boot the server as described in "Powering On and Booting the

Server" on page 7 of this guide.

6. Perform initial software setup as described in Chapter 2 of this guide.

7. Configure your server to customize it for your use. Refer to the Sun Fire V20z

Server Management Guide for details.

™

V20z server, including the front and back panels.

of this guide for an illustration of

FIGURE 1-5

Table of Contents

Do you have a question about the sun fire V20Z and is the answer not in the manual?