Direct Station Selection; Transferring An Outside Call - ESI 50L User Manual

User's Guide

Direct station selection

Programming some of the programmable feature keys (see p. C.2) as station keys will provide direct access to
those stations as well as providing lamp information as to their status. The station keys' LEDs indicates the
status of the station assigned to each key:
If a station key's LED is . . .
Unlit
Red; steadily lit
Red; blinking
Green; steadily lit
Green; blinking
Amber; steadily lit
Note: Each ESI Cordless Handset has only red LEDs, and only on its four programmable feature keys.
The illumination activity (such as blinking) otherwise is similar to that described above.
To call another station programmed into one of your station keys:
1. Press an available (unlit) station key.
2. The called station will sound a short ring followed by a double connect tone.
3. The system will activate the called station's speakerphone (or the station will ring if that station's user has
hands-free answer disabled).
4. To disconnect when finished, do one of the following:
•
Replace the handset.
•
If in hands-free mode, either press the station key again or press SPEAKER.
•
Press RELEASE. (With a Cordless Handset, press TALK or put the Handset in its charging cradle.)
If you press a key for a station that's in use (red; steadily lit), you will "camp onto" the station, where its Feature
Phone's display will tell its user that you're waiting (see "Call waiting," page E.11).
If you press a key for a station that's in DND (amber; steadily lit), you'll be forwarded directly to the
person's mailbox.

Transferring an outside call . . .

. . . to another station
Blind transfer
1. While connected to an outside call, press a station key (or press TRANSFER and then dial the
extension number).
2. Hang up.
Note: If the called person doesn't answer, the caller will be forwarded either to the called person's mailbox
or another destination the Installer has programmed.
1
If your system is using ESI Presence Management, your phone's MUTE/DND key won't turn amber when you exit the building using your electronic
key; for more details, refer to the ESI Presence Management User's Guide (ESI part # 0450-0793). If you're not sure whether your
system is using ESI Presence Management, consult your System Administrator. For more information about ESI Presence Management, visit
www.esi-estech.com/presence.
The station assigned to that key is . . .
Available; currently unused
In use
Ringing from another call
Connected to you (including via voice mail)
Ringing from your call
1
In DND mode
ESI Feature Phone operation
E.5