Override Ring - ESI 50L User Manual

User's Guide
3. Press 9 (W X Y). The display will show the first stored name that starts with W, X or Y.
4. Continue to press 9 until XYZ COMPANY appears in the display.
5. Press DIAL. This dials the number for the XYZ Company.
Important: The number dialed (if stored from a Caller ID) will be the number for the actual line used by
System speed-dialing with Esi-Dex
If your administrator has programmed system speed-dial numbers, you can access one of these numbers
either via Esi-Dex, as explained in the foregoing discussion, or auto-dial it by dialing its corresponding three-
digit access number (in the range 600–699).
Example: If an out-of-town factory location has been programmed as system speed-dial access number 605, you can
lift the handset, receive internal dial tone, dial 6 0 5 and this will automatically dial the factory's number.
You may also program 605 (in this example) as a programmable feature key (see page C.2).

Override ring

(Not available on 12-Key Feature Phone.)
The override ring feature lets you place a call — station-to-station or outside line — or leave a voice message
when another call is ringing.
Placing a call using the override ring feature
First, program a feature key
to bypass an incoming station or line call:
1. Before you begin the call, press the Override Ring Key you programmed. When you do this,
don't take the handset off-hook and don't press either a pre-assigned headset key (see page F.15), a
preprogrammed line key or SPEAKER.
2. Once you receive dial tone, pick up the handset and proceed with your call as you normally would. The
incoming call will be rerouted to the forwarding destination (such as your voice mailbox) your Installer or
System Administrator has set for your station.
Notes: Any other feature keys not mentioned above will neither answer a call nor initiate the override ring feature.
Use of the Override Ring Key also overrides any outside dial tone preference (see page F.13) that may
have been set for your station.
1
See "Programmable feature keys," page C.2, for full details.
2
The override ring feature has no effect on calls ringing in from a hold recall or a queued line..
the caller, and may be different than the caller's listed number. Additionally, some local calls
may not be auto-dialed correctly, depending on the limitations of your area's local dialing
plan. You may wish to create a manual listing for these. Consult your administrator if you
need further assistance.
1
to be an Override Ring Key — by assigning to it the function code 5 8 0. Then,
2
Special keys
F.9