Call Settings - Emblaze-VCON xPointS User Manual

Chapter 7. Advanced Settings

Call Settings

In the Call Settings window you can define miscellaneous technical settings that
affect how videoconference calls are performed by default.
xPoint Standard (S) Ver. 1.5 User Guide
o Sleep Timeout – Duration of idle time (in minutes) before the
system goes into sleep mode.
3. Select Apply.
To configure call settings
1. Select Settings>General>Calls; the Call Settings window appears.
Figure 21. Call Settings Window
2. In the Call Settings window, set the following options and parameters
o Auto Answer – Enables auto answering of incoming calls. Does not
apply to MCU or IMC calls.
o Enable H.239 – Enables data sharing protocol.
o Enable adaptive bandwidth adjustment – Enables
videoconferences to precede at reduced bandwidth if the network is
congested. Deselecting this option maintains a constant quality to the
session, but it may cause network problems.
o Auto mute microphone upon incoming call – Enables auto
muting the microphone for incoming calls
o Force FEC – Force Forward Error Correction (FEC) – Forwards an
error-correction code instead of automatically adjusting the
bandwidth.
Call Settings
• 53