Auto-Answering Calls; Ending Calls - Emblaze-VCON xPointS User Manual

Chapter 4. Videoconferencing

Auto-Answering Calls

The auto-answer option is found in the Call Settings window (see
When the auto-answer option is not selected and an incoming call is received, a
message is displayed on the screen. You can accept or reject the call using the
buttons on the remote control, or via the screen message (Yes/No).

Ending Calls

You can disconnect the current videoconference call at any time.
xPoint Standard (S) Ver. 1.5 User Guide
Figure 12. A Call is Placed
When the call is answered on the far end, the system switches to Call mode.
Note: auto-answering does not apply to MCU or Interactive Multicast
calls.
To end the current call:
On the remote control, press the red End Call button,
– or –
Select Hang Up in the GUI and then press OK on the remote control.
Auto-Answering Calls
Call Settings).
• 27