Table of Contents
Advertisement
9
TROUBLESHOOTING
PROBLEM
The transceiver does
not turn ON.
No sound from speaker. • Squelch level is too high.
Transmitting is impos-
sible, or high power can
not be selected.
Scan does not start.
No beeps.
Distress call cannot be
transmitted.
118
POSSIBLE CAUSE
• Bad connection to the power supply.
• Volume level is too low.
• Speaker has been exposed to water.
• Internal speaker is turned OFF.
• Some channels are programmed for low
power or receive only in regulations.
• The output power is set to low.
• TAG channel is not programmed.
• Beep tones are turned OFF.
• The squelch is open.
• MMSI (DSC self ID) code is not programmed. • Program the MMSI (DSC self ID) code.
SOLUTION
• Check the connection to the transceiver.
• Set [SQL] to the threshold point.
• Set [VOL] to a suitable level.
• Drain water from the speaker.
• Turn the internal speaker ON in Set mode.
• Change channels.
• Push [H/L] to select high power.
• Set the desired channels as TAG channels.
• Turn the beep tone ON in Set mode.
• Set [SQL] to the threshold point.
REF.
pgs.
,
109
110, 112
p. 8
p. 8
p. 13
p. 107
pgs. 7,
8, 121
p. 8
p. 16
p. 107
p. 8
p. 18
Advertisement
Chapters
Table of Contents
