Increasing The Printhead Gap (Head Up); Paper Width (Pagewid) - Dascom T2150 User Manual

Advanced menu
Increasing the printhead gap
(Head up)
Head up=Off *
Set < > Exit
1 2 3 4
1
2
3

Paper width (Pagewid)

Head up Pagewid
Back Next
1 2 3 4
Pagewid=136/10"*
Set < > Exit
1 2 3 4
86
With this function you can increase the printhead gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting:
Online
If the parameter is set to On, the printhead gap increases during
form feed and line feed four lines before and after the perforation on
Setup
the form (= protected zone). The printhead gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
2
Printing is possible in the protected area.
6
Confirm the setting by pressing the Set (1) key.
5
4
1 Top edge of form
2 Paper transport strip
3 Bottom edge of form
This parameter determines the actual paper width.
Select the Pagewid menu (3)
Online
Setup
Setting options: From 20 to 80 in 1/10 inch steps (narrow printer)
Online
Default setting:
Setup
If Head up = On, the printhead moves to the calculated centre of the
paper during the time the paper is moving in the protected zone. If
Rightzo = On (see below), the printhead moves out of the perfora-
tion zone on the right as long as the paper is being transported.
Set the printing width rather than the actual paper width.
Confirm your settings with the Set key (1) and press the Next key (4)
to access the next group of parameters.
Off
4 Form separation perforation
5 Protected zone
6 Transport holes
From 20 to 136 in 1/10 inch steps (wide printer)
80 or 136/10 inch
(80/136 characters at 10 characters/inch)
User guide