Messages In The Lc Display - Dascom T2150 User Manual

The control panel
Messages in the LC
display
14
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Initializing). Below you
will find a list of messages with brief descriptions of each message.
The messages are described in greater detail in the chapter (see
ror messages via the display, page 100).
Message
Eject error
Hardware Alarm
Initializing
Load error
Load paper from
Loading default
Out of paper
Parity error
Park position
Press any key
Selftest
Tear Paper off
Meaning
The printer cannot eject the paper/
advance it to park position.
Internal hardware error, contact your dea-
ler or service technician.
This message appears during the prin-
ter's initializing phase after switching on
the printer.
The printer cannot draw in the loaded
paper.
The printer has detected paper end
during operation/printer was switched on
with no paper loaded.
Factory defined parameters will be
reloaded in all available menues after
switching on the printer.
The printer has detected paper end
during operation / printer was switched on
with no paper loaded.
A parity error during data transmission is
indicated.
Printer was switched on with no paper
loaded.
The user is requested to press any key.
After power-on, the printer executes a
short hardware self-test.
The user is requested to tear off paper
which has been advanced to the tear
edge.
User guide
Er-