Paper Handling (Paphand); Increasing The Printhead Gap (Head Up) - Dascom Tally T2380 User Manual

Advanced menu

Paper handling (Paphand)

Paphand CX-bid
Back Next
1 2 3 4
Head up Pagewid
Back Next
1 2 3 4
Increasing the printhead gap
(Head up)
Head up=Off *
Set < > Exit
1 2 3 4
1
2
3
7
104
The Paphand group of menus improves the possibilities for the trou-
blefree printing of paper with properties likely to cause problems
(perforations etc.) or paper of poor finish.
Put the printer into Test mode by pressing the key Online while
switching on the printer. The display shows ASCII80 ASCII136.
Change to the parameter group Formlen AGA by pressing the key
Next three times.
Select the Paphand menu (2).
Online
Setup
Select the Head up menu (2).
Online
Setup
With this function you can increase the printhead gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting:
Online
If the parameter is set to On, the printhead gap increases during
form feed and line feed four lines before and after the perforation on
Setup
the form (= protected zone). The printhead gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
2
Printing is possible in the protected area.
6
Confirm the setting by pressing the Set (1) key.
5
4
1 Top edge of form
8
2 Paper transport strip
3 Bottom edge of form
4 Form separation perforation
Off
5 Protected zone
6 Transport holes
7 Left Zone
8 Right Zone
User guide