Placing Your Printer - Dascom T2150 User Manual

Installation

Placing your printer

6
Do not expose the printer to direct sunlight. If you cannot avoid plac-
ing the printer near a window, protect it from the sunlight with a cur-
tain.
When connecting the computer with the printer, make sure not to ex-
ceed the permitted cable length (see
page 113).
Ensure sufficient distance between the printer and any heating radi-
ators.
2
1
0
C
Avoid exposing the printer to extreme temperature or air humidity
90
80
70
60
50
fluctuations. Above all take care to avoid the influence of dust.
40
30
20
10
0
-10
It is recommended to install the printer in a place which is acousti-
cally isolated from the workplace because of the noise it may
produce.
Place the printer on a solid, flat, surface, ensuring
that the printer is positioned in such a way that it
can not topple, and that there is easy access to the
control panel and paper input devices. Also ensu-
re that there is sufficient space for the printed out-
put.
If you expect that frequent forward and reverse
feeds will occur, you should place the printer as
shown in the figure, if possible.
The power supply cable may be dama-
STOP
ged if the paper edges constantly chafe
the insulating sheath. The user must
always ensure that there is sufficient
distance between the power supply
cable and the paper.
When selecting the printer location, observe the
following additional instructions:
Never place the printer in the vicinity of
STOP
inflammable gas or explosive sub-
stances.
Interface
User guide
specifications,